Manual tk-3301

See also: Instruction Manual. Table of Contents. This product uses Lead Free solder. Previous Page. Next Page. Page 2: General Kenwood reserves the right to make changes to any wise, for any purpose without the prior written permission products herein at any time for improvement purposes. Modes tered immediately. When data is read from the transceiver, the red LED lights.

Remove the solder of the positive terminal with a solder- 1. Page 5 TK 3. Removing the Battery Release Lever 5. Assembling the Battery Release Lever 1. Place the lever w onto the stopper q. Place the thick spring e onto the lever. Press the upper part of the lever toward the inside of the 3.

Mounting the Chassis to the Case Assembly 8. Confirm that the waterproof packing attached to the Note that the shapes, colors and heights of nuts of the Signal Name Function Pin No. Part Name Description Ref. Side 2 key Press to activate its programmable function. VOX can only be used if you are using a supported headset. This function can be turned off for specific channels by your dealer. If you continuously transmit for the duration programmed by your dealer default is 60 seconds , transmission will stop and an alert tone will sound.

To stop the tone, release the PTT switch. The table below lists the default channel settings. Page 23 4 Press and release the PTT switch, then rotate the Channel selector to your desired channel. Your dealer can set up your transceiver with 1 of 10 calling alert tones.

If each party member uses a different tone, it is easy to know who is calling. Priority Scan: The Priority channel is a channel that is given first priority to while scanning. The Priority channel is set by your dealer. Recharge or replace the battery pack. Cannot turn the transceiver power ON. Remove the battery pack and install again. Print page 1 Print document 31 pages. Rename the bookmark.

Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password. Upload manual.